3-Link
Aisin Manual Hubs
Armor
Bikini Top Kits
Body Lifts
Brakes
Bumpers
Clutches
Differentials
Front Axle
Front Lift Kit
Leaf Springs
Optima Battery Mounts
Quick Disconnects
Rear Axle
Rear Lift Kits
Rear Spring Hangers
SAS Kits
Shackles
Shock Hoops
Shocks
Sliders
Spring Hanger Kit
Steering
Transfer Case
U-Bolt Flip Kits
Tube Doors

Contents:
-10 High Strength Allen Head Bolts
-10 Flat Washers
-10 Lock Washers
-10 Nuts
-Ultra Gray Silicon Gasket Material

If you have any questions during the installation of your kit, please contact us for assistance.

Preparing the Axle Start by removing the axles from the housing.  Remove the 10 nuts holding the differential in place.  Slide differential out of housing.  Remove all 10 studs from housing.  Clean off all remains of the previous differential gasket.

Install Studs Place one flat washer on to each new bolt. Thread each bolt in from the inside of the housing. Lock-Tight thread locker can be used if desired. Tighten studs with 5mm Allen wrench.

Install Differential Once all 10 studs have been installed, spread out a thin layer of silicon over the face of the 3rd member. Slide the 3rd member back in to position on the housing. Place lock washer and nut on each stud. Tighten nuts in a star pattern.

Reinstall axles into housing and fill differential with gear lube. Recheck nuts after first trail run.

Home
Sale of the Month
Apparel
Compressors
Custom Fabrication
Powertanks
Recovery
Rocklights
Wheel Spacers
Wheels & Tires