1979-1995 4Runner/PickUp
1995.5-2004 Tacoma
2005-2007 Tacoma
2005-2007 Tacoma
1996-2002 4Runner
2003-2007 4Runner
2000-2007 Tundra
2007 FJ Cruiser

Bikini Top and Channel
1. Remove the factory hardtop as per the instructions in your Factory Service Manual or Owners' Manual (you can find them online as well).

2. Attach the sides marked "driver" and "passenger" using the included hardware.  This makes your channel for securing the bikini top to the cab.  Simply tighten until snug and do not over tighten as once you attach the channel to the cab you will want a bit of play to get things properly aligned.

3. Attach the FJ40 bikini top (not included in the WabFab bikini top kit but must be purchased separately) to the channel.  Evaluate where the center of the bikini top is relative to the center of the channel and slide the bikini into the channel using the plastic strip at the front of the bikini top.  Once installed, double check to make sure the bikini top is centered in the channel.

4. Attach the bikini top and channel to the cab.  Place the bikini top and channel onto the ledge on the rear of the cab.  Loosely install the two center bolts (you will need four from your hardtop).  Since the rubber seal will be in different conditions on different trucks, now might be a good time to recondition it before you finish the install so you get a good water tight seal.  The holes in all four brackets are oversized for final adjustment for the tightest fit.  Next install the two outermost bolts.  Please note that you will have to bend the channel down a little bit on both ends to get the bolts in as this provides for a tight fit.  Once all the bolts are started firmly in the holes, tighten them up so they are snug.

5. Attach the straps to the bed wherever you decide works best for you.  The footman loops will come with the FJ40 bikini top you purchase separately and have instructions for installation.  The straps for the bikini top will be too long so plan on cutting them down and restitching them or doubling them up and restitching.

Rear Bow
1. Attach the two sides of the bow together using the supplied hardware and coupling.

2. Wrap the top center of the bow with the insulation taking care to measure ahead of time. You will want the insulation to be on the rear bow everywhere the bikini top touches it, but not sticking out the sides.

3. Attach the bow to the factory roll bar using the supplied hardware in the two threaded holes on the inside of the roll bar.

4. Adjust the bow so that it fits snugly up against the underside of the bikini top to give it shape and support for when driving at highway speeds and to keep water from gathering on top of the bikini top in the rain.

5. Once the desired position is set, snug down the bolts and use a strap or a bungee cord from the top center of the roll bar to the center of the top of the bow to keep the bow from being pushed down when driving at highway speeds.

6. Adjust as necessary over time.

If you have any questions during installation, please do not hesitate to Contact Us.

Home
Sale of the Month
Apparel
Compressors
Custom Fabrication
Powertanks
Recovery
Rocklights
Wheel Spacers
Wheels & Tires